1903 American Tool Works Company Lathe Project Page 2


Project Lathe Clutch (November-18-2005) (new camera Sony Mavica MVC FD91) (Hand Made)


Project Lathe Clutch (November-18-2005) (Hand Made)


Project Lathe Clutch (November-18-2005) (Hand Made)


Project Lathe Clutch (November-18-2005) (Hand Made)


Project Lathe Clutch (November-18-2005) (Hand Made)


Leadscrew is inside the lathe bed and thats the smallest orbs i have ever seen (November-18-2005)


Project Lathe Transmission Selector Numbers
took a while to find the numbers (December-17-2005) (Hand Made)


PROJECT Lathe Threading Dial
Lathe Threading Dial in the Works (February-26-2006) (Hand Made)

PROJECT lathe drip pan
i knew that Gray Poupon Mustard jar would come in good for something, i couldn't eat the stuff
also Project Chip Box under the lathe (May-23-2006) (Hand Made)

PROJECT Much Needed Lathe Chain Guard (June-15-2006) (Hand Made)
this years gearing ratio
motor 1740 rpm
motor belt Pulley 3 inches
jackshaft belt pulley 3-3/4
jackshaft Spocket 7 inches, 42 tooth
Transmission Spocket 8-3/4 inches, 54 tooth
belt drum on transmission 4-1/8 inches
Cone Drum on Lathe 13 inches
1963 ford van transmission

PROJECT hogging down to a 1/2 shaft, this is for a tailshaft end extension for a Chrysler Outboard 32 cu in 4 cylinder air cooled military engine (October-15-2007)

PROJECT 3/8 big lathe chips, the power of a 1903 ATW flat belt lathe (October-15-2007)

PROJECT American Lathe Apron T Slot Covers, made from 5/8 Pulley V Belt (October-23-2007)

Back to 1903 American Tool Works Company Lathe Project Page 1
Stans Project Page 13

1  2  3  4  5  6  7  8  9  10  11  12  13  14  15  16  17  18  19  20  21