American Tool Works Company Lathe "20 x 106" Lathe this project has taken 2 years and is still going on (JULY 2003)
American Tool Works Company 20 Inch Lathe - Leveling mounts made out of 4 inch round
American Tool Works Company Lathe "20 x 106"
American Tool Works Company Lathe, 11 QuickChange Gears
Cushman Chuck Company
the American Tool Works Lathe Was Sold At Carolina Supply Co. General Mill Supplies Greenville S.C.
American Tool Works Company Lathe Last Patent April 14-1903
American Tool Works Company Lathe Apron
American Tool Works Company Lathe Cross Slide Dial
100 Year Old 16 inch Cushman Chuck (JULY 2003)
American Tool Works Company Lathe, Speeds & Feed Chart
1963 Ford Van Transmission Powers This American Tool Works Lathe 5 hp ele motor, 3 inch flat belt, 3 speed back Gear
they must have had good eyes back then, Compound Slide Dial
update August 20 2003, jackshaft to slow the lathe down. (Hand Made)
update September 1 2003, tailstock crank was added. (Hand Made)
Project BackPlate October 29 2005, it's Heavy (Hand Made) this picture and the next 2 were taken with a DXG-308 digital camera and boy it sucks!-yep looking for a new camera
Project BackPlate October 29 2005, Less Heavy (Hand Made)
Project BackPlate October 29 2005, Getting There (Hand Made)
Project BackPlate October 29 2005, 3 Jaw 13 inch Chuck Finally Installed Rome was not Built in a Day and Neither was this backplate, took 3 weeks and 3 days (new camera Sony Mavica MVC FD91) (Hand Made)
